AC/DC Current Sensor for Rotating Applications.

There are several techniques for current measurement. Most of them are capable of measuring both alternating and direct current (AC/DC) components. However, they have severe drawbacks for rotating applications (large size, sensitivity to external fields, and low signal amplitude). In addition to these weaknesses, measured signals should be transmitted to a stationary part. In order to contribute solving these difficulties, this paper presents a sensor that can measure AC/DC simultaneously based on the electromagnetic coupling of two coils. To this aim, the measured waveform is analysed. In this paper, the design of such a sensor is presented. This design is validated through computer simulations and a prototype is built. The performance of this sensor prototype is analysed through experimental tests.

Fluid Degradation Measurement Based on a Dual Coil Frequency Response Analysis.

Electrical industry uses oils for cooling and insulation of several machines, such as power transformers. In addition, it uses water for cooling some synchronous generators. To avoid malfunctions in these assets, fluid quality should be preserved. To contribute to this aim, a sensor that detects changes in fluid composition is presented. The designed sensor is like a single-phase transformer whose magnetic core is the fluid whose properties will be measured. The response of this device to a frequency sweep is recorded. Through a comparison between any measurement and a reference one corresponding to a healthy state, pollutants presence, such as water in oil or salt in water, can be measured. The performance of the sensor was analyzed through simulation. In addition, a prototype was built and tested measuring water concentration in oil and salt content in water. The correlation between pollutant concentration measured with the sensor and known pollutant concentrations is good.

Performance Problems of Non-Toroidal Shaped Current Transformers.

Nowadays, non-toroidal shape primary pass-through current transformers are commonly used for large current machines with several cables per phase. As these transformers exhibit no radial symmetry, it is not clear if they can be tested using the indirect test described in the IEC 61869 standard. In order to answer this question, two non-toroidal shaped current transformers of different secondary winding designs have been tested and simulated. One transformer has a uniformly distributed secondary winding and the other has a partially distributed secondary winding. Both transformers have the same nameplate characteristics. Both perform correctly in the indirect test. However, only the transformer with the uniformly distributed secondary winding performs correctly in a direct test. A finite element simulation shows that the iron core of the partially distributed secondary winding transformer was saturated, while the iron core of the uniformly distributed one was not. This result explains their different performance. The main conclusion is that the indirect test is not sensitive enough to cover all cases and therefore under doubtful situations, the transformers should be tested using the direct test.